好想被狂躁A片视频免费_女女百合高h纯肉视频_乳腺增生最好的自愈方法_亚洲妓女综合网99_老头把我添高潮了A片久久

原理

具有分散作用的風機，特別適合熱敏性物料的氣流干燥作業。高速飛旋的風機葉輪，能把濕的、甚至結塊的物料解碎，直至分散，在分散過程中同時攪拌、混合，然后物料和熱氣流平行地流動。這種類型的設備，適應干燥濾餅結塊的，但還屬于表面水份的物料，含濕量≤40%，如果處理量大或者成品要求干至15%以下時，可采用二級氣流干燥。當物料含濕量超過40%，但量≤60%，進料較困難，應采用混料器，通過混進干料的方法以降低進料水份，此時，干燥設備的總產量就有較大幅度的下降，這在經濟上是不合算的。因此，用戶應先用機械的方法(離心脫水或壓濾)盡可能的降低進料水份，以確保干燥作業上的順利進行。

Principle

The fan with the function of dispersion is particularly suitable for airflow drying of heat-sensitive materials. The high-speed fan impeller can break and separate the wet and even caked materials. During the dispersion, materials can also be agitated and mixed. Then the materials flow in parallel to hot air flow. Such equipment is applied to the drying of filter cake, but it still belongs to the material with moisture on the surface, with moisture content ≤ 40%. If the amount of materials to be handled is large or the finished products are required to be dried to have a moisture content of less than 15%, the secondary airflow drying can be adopted. When the moisture content of the materials is more than 40%, but less than or equal to 60%, the charging will become difficult. The mixer should be adopted to mix dry materials in order to reduce the moisture content of charging materials. At this time, the total output of the drying equipment will be greatly reduced and it's not economical. Accordingly, the user should make use of the mechanical method (centrifugal dewatering or pressure filtration) to reduce the moisture content of charging materials as far as possible,